Preparation of the bus roof Installation instructions REVO-E
26
3.3. Cleaning the vehicle’s roof
Once all roof cut-outs are made, the roof must be cleaned.
3.4. Installation using Armaflex frame
When mounting / sealing the air-conditioning unit with an Armaflex
frame, the areas on the vehicle’s roof must be pre-treated with a clean-
sing agent / primer for bonding. Follow the processing instructions pro-
vided by the manufacturer of the adhesive material.
NOTE:
The customer is responsible for the selection and verification of the
adhesive material’s bonding with the vehicle’s roof / Armaflex frame.
3.5. Installation using a mounting frame
The requirements in 3.1. are valid.
The mounting frame will bonded to the vehicle’s roof. The intended
adhesive areas of the mounting frame on the roof are to be treated with
an appropriate cleaner / primer for bonding.
NOTE:
Follow the processing instructions provided by the manufacturer of the
adhesive material.
Figure 6: Mounting frame
Figure 7: Mounting frame bracket attachment
To Next Page
