6.6.2 Continuous Mode
In Continuous mode a set of observations will be recorded at a rate of 1Hz. Data will be recorded
from the moment the Instrument is set to work and will continue until the Instrument is interrupted.
Once the unit is placed into run mode, either by turning the SWiFT on, or sending a run command:
.
the following criteria must be met before logging will start:
• A Valid position has been obtained if the 'Require GPS fix before logging' option is ticked
or
• If the 'Require GPS fix before logging' option is not ticked as soon as the SWiFT is turned on
and set to work.
Observations will be recorded at 1 Hz in continuous mode.
In a SWiFT this 1Hz recorded value is the average of a 32Hz observation period for each sensor.
Logging is stopped by turning the instrument off or Interrupting it with a # character.
To Next Page
Loading...
