Valet 562T - Transmitter Configurations; Button Configuration; Operating Settings Learn Routine

© 2005 Directed Electronics—all rights reserved
2299
ttrraannssmmiitttteerr ccoonnffiigguurraattiioonnss
The transmitters can be programmed with the separate or single button arm/disarm configurations by using the
Auto-learn functions in the Transmitter/Receiver Learn Routine.
controls the
LLoocckk//PPaanniicc OONN//PPaanniicc OOFFFF
function.
controls the
UUnnlloocckk
function.
controls
SSiilleenntt MMooddee™™
and an
AAuuxxiilliiaarryy OOuuttppuutt
.
controls Remote Start.
+ controls
TTiimmeerr
mode.
+
controls
TTuurrbboo//SShhoorrtt RRuunn
.
+ controls
CChhaannnneell 44
output.
+ + controls
RReeaarr DDeeffooggggeerr
on/off
ooppeerraattiinngg sseettttiinnggss lleeaarrnn rroouuttiinnee
The System Features Learn Routine™ dictates how the unit operates. Due to the number of features, the
features have been divided into two menus. It is possible to access and change any of the feature set-
tings using the Valet/Program switch. However, this process can be greatly simplified by using the Bitwriter®.
Any of the settings can be changed and then assigned to one of up to four transmitters, a feature called Owner
Recognition. Each time that particular transmitter is used to disarm the system, the assigned feature settings
will be recalled. Owner Recognition is only possible when programming the unit via the Bitwriter®.
bbuuttttoonn ccoonnffiigguurraattiioonn