Valor 541 - To Remove the Complete Burner Module; To Remove the Burner from the Burner Module

16.5 To remove the complete burner module.
- Remove the fascia (See section 17.1).
- Remove the window unit (See section 17.2).
- Lift out the ceramic fuel effect and rear wall (See
section 17.3).
- Isolate the gas supply using the inlet ‘T’ connector
on the appliance.
- Unscrew the nut from the top of the inlet ‘T’
connector.
- Detach the battery box from the fire unit by removing
two screws (See figure 49).
- Detach the burner front cover by unscrewing the 10
screws at the front of the burner module
shown in figure 50.
- Slowly ease the burner module forward
and clear ensuring that the thermocouple
does not catch on the bottom of the
firebox.
- Replace in reverse order.
- When replacing, make sure that the
wiring loom runs above and to the right of
the battery box and behind the control
valve (See figure 51). The motor lead
connectors are two different sizes. They
will only fit to the correct motor terminals.
16.6 To remove the burner from the
burner module.
- Remove the complete burner module as
in section 17.5
- Support the injector elbow and unscrew
the pipe nut from its base.
- The burner bracket is secured to the
front cover by four screws. Remove these
screws.
- The burner and its bracket can now be lifted clear of the module.
- If replacing the burner unscrew the two nuts securing the burner bracket to the
burner. Remove the burner.
- Replace in the reverse order.
- When replacing, make sure that the wiring loom runs above and to the right of the
battery box and behind the control valve (See figure 51). The motor lead connectors
are two different sizes. They will only fit to the correct motor terminals.
Page 38
© GDC Group Ltd. 2014
INSTALLER GUIDE
Figure 49. Bracket may
differ from that shown
Figure 50. Burner module fixing screws.
Figure 51. Wiring loom route.