To light the main burner.
- Partially depress the right control knob and turn to the main burner position marked
.
- The main burner flames are controlled by using the rocker switch at the right side of
the fire case. Operating the rocker switch automatically causes the knob at the left
side of the pilot control knob to rotate. Pressing in the top half of the switch turns the
main burner on. Keeping the top half pressed gradually increases the flame height
and heat output. Pressing the bottom half reduces the flame height and heat output
and finally turns the main burner off. In the unlikely event of failure of the rocker
switch, the left side knob can be turned manually.
To turn off the main burner only.
- Press in and hold the bottom half of the rocker switch until the main burner is
extinguished. Alternatively, the main burner can be extinguished by turning the right
hand control knob to the pilot position marked .
To turn off the main burner and pilot.
- Turn the right hand control knob to the pilot position marked . Push the knob
in at this position and turn to the off position marked
•
.
CLEANING YOUR FIRE
Turn the fire off and allow it to cool completely before attempting any cleaning. Note
that the fire will retain heat for some time after it has been turned off.
Metal parts.
Clean the metal parts with a slightly damp cloth and then dry. Do not use abrasive
cleaners, they could scratch the surface.
Page 48
© GDC Group Ltd. 2014
OWNER GUIDE
To Next Page
Loading...