- When lifting always keep your back straight. Bend your legs and not your back.
- Avoid twisting at the waist. It is better to reposition your feet.
- Avoid upper body/top heavy bending. Do not lean forward or sideways whilst
handling the fascia.
- Always grip with the palm of the hand. Do not use the tips of fingers for support.
- Always keep the fascia as close to the body as possible. This will minimise the
cantilever action.
- Use gloves to provide additional grip.
- Always use assistance if required.
1. The bottom of the fascia is held in place with thumbscrews. Unscrew and
remove the thumbscrews from the perforated panel. Hold the lower outside
edges of the fascia and gently pull forward. Lift the fascia upward and clear of
the upper hanging brackets on the convection box.
2. The window panel is secured at the bottom with two clamps. To release the
clamps, hold at the rear and pull down (See figure 7).
3. With both clamps released, gently pull the base of the window panel forward.
Hold the window panel base and lift upward until clear of the two upper window
retainers (See figure 8).
© GDC Group Ltd. 2013
Page 50
OWNER GUIDE
Figure 7. Window panel clamp
Figure 8. Window removal
To Next Page
Loading...
