CONTENTS (Continued)
Section Heading Page
10. BURNER INSTALLATION 27
10.1 Burner and supply pipe installation. 27
10.2 Preliminary burner checks. 27
10.2.1 Lighting the burner. 27
10.2.2 Operating the burner. 27
10.3 Inlet pressure check. 28
10.4 Fitting the burner tray trim. 28
11. FITTING THE FASCIA 28
12. FITTING THE CERAMIC FUEL EFFECT 29
13. FIREFRONT CASTING INSTALLATION 30
13.1 Fitting the Alpha, Eternal, Elegant and Obsession firefront casting. 30
13.2 Fitting the Dream, Masquerade and Excelsior firefront casting. 30
13.3 Fitting the Decadent firefront casting. 30
14. FULL OPERATING CHECKS 31
14.1 Recheck the control settings. 31
14.2 Lighting the burner. 31
14.3 Operating the burner. 31
15. SPILLAGE AND FLAME SUPERVISION CHECKS 32
15.1 Check for spillage. 32
15.2 Flame supervision and spillage monitoring system. 32
16. FINAL REVIEW 34
17. SERVICING & PARTS REPLACEMENT 35
17.1 Checking the aeration setting of the burner. 36
17.2 To remove the ignition microswitch. 36
17.3 To remove the gas shut-off microswitch. 36
17.4 To remove the fascia. 37
17.5 To replace the control slide button. 37
17.6 To remove the burner unit. 38
17.7 To remove the electronic ignition generator. 38
17.8 To remove the thermocouple interrupter block. 38
17.9 To remove the pilot unit. 39
17.10 To remove the shut-off tap. 39
17.11 To remove the gas flow rate controller. 40
17.12 To replace the burner. 40
17.13 To remove the main burner injector. 41
17.14 To remove the appliance from the fireplace. 41
Page 6
© GDC Group Ltd. 2013
INSTALLER GUIDE
To Next Page
Loading...
