11
WiFi Module Kit (GV60WIFI)
Hardware
The GV60WIFI kit consists of:
• WiFi module
• Receiver connector cable
See "Hardware Requirements" on page 2 for full
details.
Installing the WiFi Module
See "Wiring Diagram" on page 4 for details.
1. Disconnect all power sources (even if you just
installed the Receiver). Unplug V-Module from the
receptacle and disconnect the battery pack.
2. Wait 1 minute for unpowered Receiver to reset.
3. Replug the V-module to the receptacle.
4. Connect cable from the WiFi module's RECEIVER
port to the SI port on the Receiver.
5. Connect battery pack to Receiver.
6. Attach Velcro and place the WiFi module inside the
front panel of the fi replace per the diagrams to
the right in Module Installation Location. The mod-
ule should be placed with the RESET button facing
toward the user.
Attention!
It is important that the main power is connected
before the battery pack. This prevents the WiFi
module from draining power from the batteries.
WiFi cable
(to Receiver
SI port)
Module Installation Location
For Linear fi replaces (L1, L2, L3, LT1, and LT2) and LX1,
place the WiFi module just to the right of the control
valve, as indicated below.
For the LX2, place the WiFi module on the inside of the
access plate as far to the left as possible, as indicated
below.
For H5 and H6 fi replaces, place the WiFi module in the
right hand end of the controls area as indicated below.
For P2 fi replaces, place the WiFi module in the back
right corner of the bottom of the fi replace, behind the
valve, as indicated below.
Your installation is now complete. You may now
proceed to
"Valor 10 WiFi Control Software Instructions",
document 4007972.
L1/LT1 L2/LT2 L3
LX1
LX2
H5/H6
P2
Note
This Section applies to all fi replaces.
To Next Page
Loading...
