2
Hardware Specifications
Kit Description
Linear Fireplaces (L, LX, and LT) H5 and H6 Fireplaces
P2
Fireplaces
1500I,
1700I
1500J, 1700J,
1800J, 2200J
1500K,
1600K,
1700K, 1800K
2100K,
2200K
2500K,
2700K
1100M,
1400M
1100I, 1100J, 1150I,
1150J, 1400I, 1400J,
1400K
200A
RCK400 Valor 10 Receiver /
Remote Kit
Included Incl Incl Included Included
n/a Junction Box
** ** Included Incl Incl
Incl with H6
1400M
H5/6-WPK H5 and H6 WiFi
Power Kit
†
H5 1100M
only
†
P2-WPK P2 WiFi Power Kit
‡
GV60VM V-Module Kit (V3)
Incl * † * † ‡
GV60WIFI WiFi Module Kit
Hardware Requirements
Depending on which model fi replace you are installing the upgrade on, the hardware required will be diff erent. There
are three diff erent hardware kits that may be required. They are listed below by fi replace - check your fi replace's
information card to identify its model.
Any kit marked with a is required - be sure you have all required kits before starting the upgrade.
Notes - Existing Electrical Accessories
L1 1500, L2 1700 or L3 1800 fi replaces
• Your fi replace may have been already installed with an optional fan (1595CFK) and/or optional lighting kit (1565LLK).
These kits are operated independently from the remote control and cannot be operated with the WiFi system and
Valor 10 Remote Control or Valor 10 Application.
• If an optional 1595CFKV2 fan has been installed, it has a GV60VM V-Module already and can be operated by WiFi/
Valor 10 Remote control and Application.
LX1 2100 or LX2 2200 fi replaces
• Your fi replace is supplied with ambient lighting above the burner. The lighting can be operated with the WiFi sys-
tem, Valor 10 Remote Control or Valor 10 Application. The existing V-Module provided with these fi replaces may not
be compatible with the WiFi upgrade, in which case, you may need the V-Module Kit GV60VM - see specifi cations of
required components next page.
* If your H5 or H6 has an 1195CFK optional fan kit installed, verify the power module installed is a G6R-BUMV3
(see GV60 (V-Module Kit) on next page for details). If it is not a V3, you will need to order the GV60VM kit.
** Series I and J Linears: If no electrical accessories are already installed, a standard junction box with receptacle
must be installed. See your fi replace's installation manual.
† If your H5 or H6 has no fan kit installed, you will need to order the GV60VM and H5/6-WPK kits.
‡ If your P2 has no fan kit installed, you will need to order the GV60VM and P2-WPK kits.
All Models
Note
If you are unsure of whether the equipment in your
installation meets requirements, please contact your
local Valor dealer: valorfi replaces.com/contact/
To Next Page
Loading...
