5
Hardware
The H5/6-WPK kit consists of:
• An electrical housing
• An electrical snap-in socket
See Hardware Requirements on page 2 for full
details.
Installing the WiFi Power Kit
See "Wiring Diagram" on page 4 for details.
1. Make sure supply power is disconnected before
proceeding.
2. Thread the home's electrical wire inside the appli-
ance casing on the left hand side using an approved
wire clamp for the type of wire used (not included).
Do not tighten the wire clamp just yet to allow for
wire adjustment.
3. Place the junction box cover in the front left corner
of the appliance case.
Electrical
wiring enters
through the
left hand
side of the
appliance case
(front round
hole)
4. Slide the tab at the far end of the box into the slot of
the appliance case located
right behind the cable
clamp. Ensure the wires
are not pinched between
the junction box and the
appliance case.
5. Connect the corresponding wires and cap them with
wire nuts.
6. Tuck the wires inside the junction box and hold it
against the appliance case while pushing any excess
wire out through the wire clamp.
7. Tighten the wire clamp outside of the appliance
case.
8. Fix the junction box to the appliance (1 screw).
Proceed to V-Module Kit (GV60VM) for H5 and H6
models on page 8
Note
This Section only applies to all H5 and H6
fi replaces that do not have the optional 1195CFK
fan kit or an AC receptacle already installed. Skip
this page if this does not apply.
H5/6 Power Kit (H5/6-WPK)
H5 and H6 Models
To Next Page
Loading...
