VALTIR QuadGuard - Page 48

Valtir.com 47 Revision D November 2022
Note: A Side Panel is not needed when a Transition Panel is used. Diagonal braces not used
with some Transition Panels. See drawing package.
Assembly tip:
Use drift pin to align the center hole of the Panel with the center hole of the Backup before
attaching the rail bolts.
Figure 55
Side Panel/Transition Panel Attachment
TENSION STRUT BACKUP
3/8” X 3 1/2" HEX BOLT
3/8” LOCK WASHER
CONCRETE BACKUP
5/8” RAIL NUT (LARGE)
(p. 50)
5/8” LOCK WASHER
3/8” HEX NUT
DIAGONAL BRACE (OUTER)
3/8” X 3 1/2"
HEX BOLT
5/8” X 4" HEX BOLT
DIAGONAL BRACE (INNER)
HINGE PLATE
5/8” HEX NUT (SMALL)
3/8” LOCK WASHER
5/8” RAIL BOLT
WIDE SIDE PANEL
3/8” HEX NUT