Valtra Q Series

CRUISE CONTROL
1.
Push the drive lever to the right to engage cruise, hold for 2 seconds to store the new speed.
2.
When cruise control is activated the cruise speed can easily be adjusted via the thumb wheel
located on the drive lever.
3.
Re-active cruise speed by quickly pushing the drive lever to the right.
4.
The cruise deactivates:
• by pressing brake pedals
• pushing the drive lever left
• Starting to use the drive lever
After deactivating speed is controlled by either the drive pedal or lever.
NOTE: When driving in manual mode, there works, instead of speed cruise, a Transmission Ratio memory.
ACTIVATION
DEACTIVATION
ADJUSTMENT
Together with the memory buttons
M1,M2 and M3 it is possible to save
up to four different cruise speeds at
once.
VALTRA EXPERT TIP
Q Series Quick Guide
14