3. Engage the creeper range with the speed range selection - button.
NOTE: You cannot engage the creeper range with speed ranges B, C or D
selected.
The
symbol flashes on the display until the creeper speed range
engages.
4. Release the clutch pedal.
5. Switch between the speed ranges LA and LB without disengaging traction
with the + and - button.
6. Disengage the creeper range.
• Select the speed range LB.
• Stop the tractor and press down the clutch pedal or move the power
shuttle lever to the N position.
• Disengage the creeper range with the speed range selection + button.
3.8.11.4 Using Powershift
You can change the Powershift gear with the gear lever.
NOTE: You can change the Powershift gear more than one step at a time,
directly from 1 to 3 for example, by quickly moving the gear lever to either
direction twice or more. You can also change the Powershift gear several steps
at a time by moving the gear lever in either direction and holding it there. This
triggers multiple consecutive Powershift gear changes. The number of the
selected Powershift gear flashes on the tractor terminal display and A-pillar
display until the requested Powershift gear has engaged.
NOTE: When turning the power on when it has been switched off for over 10
seconds, the Powershift is always in the lowest stage.
3. Operation
- 123 -
To Next Page
Loading...
Need help?
General