Van Rysel E-EDR AF - Page 19

19
Number Designation Resolution
30/31
OVER CURRENT PROTECTION Current supplied by the Battery Pack is too high. Please reduce the demand.
If the sy󰘵em locks, please re󰘵art the eBike Sy󰘵em. If the problem persi󰘵s,
contact your Decathlon workshop.
32
COMM FATAL ERROR Fatal Error. re󰘵art the eBike sy󰘵em. If the problem persi󰘵s, contact your
Decathlon workshop.
33/35
SPEED SENSOR ISSUE Speed Sensor error - Motor consumes but Speed not received from sensor.
Check sensor speed. If the problem persi󰘵s, contact your Decathlon workshop.
34
ACC VOLTAGE ERROR
Contact your Decathlon workshop.
129
DEMO MODE
Contact your Decathlon workshop.
193
195
CELL OVER VOLTAGE Discharge the battery and then recharge it.
Leave the battery connected to the charger for 2 hours after the charge ends to
balance the cells.
194
196
CELL UNDER VOLTAGE Charge the battery and leave it connected to the charger for 1-2 hours after
the charge ends to balance the cells. If the problem persi󰘵s, contact your
Decathlon workshop.
197
CHARGE OVER CURRENT Check that the charger is in good condition.
Let the battery re󰘵 for 2 hours. If the problem persi󰘵s, contact your Decathlon
workshop.
199
SHORT CUT Check the charging port. If the problem persi󰘵s, contact your Decathlon
workshop.
201
BATTERY IM BALANCE
Allow to charge until the error disappears (around 3 hours).
202
SHORT CUT LOCK
Connect the charger.
203
REVERSE CONNECTION Check the charging port and the charger. If the problem persi󰘵s, contact your
Decathlon workshop.
204
CHARGE OVER TEMPERATURE - Stop charging.
- Allow the sy󰘵em to re󰘵 for 30 minutes, with the bicycle turned o󰘯.
- Continue charging.
205
CHARGE UNDER TEMPERATURE - Stop charging.
- Protect the bicycle from the cold and wait until the temperature of the
cells increases.
- Continue charging.
206
DISCHARGE OVER TEMPERATURE - Reduce the discharge speed or 󰘵op for a few minutes.
- Wait until the temperature drops.
207
DISCHARGE UNDER TEMPERATURE - Avoid large power demands while this error is active to prevent deterio-
ration.
- Charge the battery within the appropriate temperature ranges.
208
FET OVER TEMPERATURE - Avoid large power demands while this error is active to prevent deterio-
ration.
- Try not to use the sy󰘵em in extreme temperatures (less than 10°C or
more than 40°C).
213
UNBALANCE CELL - Allow to charge until the error disappears (around 3,5 hours).
- If the error persi󰘵s, perform several discharge - full charge cycles (from
100% to 50% battery load).
- If after a maximum of 5 cycles, the error is 󰘵ill present at the battery,
contact your bicycle manufacturer.