Van Rysel E-EDR AF - Product Description; Technical Features; Electrical Assistance Operation

6
PRODUCT DESCRIPTION
Electrically-assi󰄋ed bike technical features
A
Battery
B
Motor hub
C
COMMAND BUTTON
D
BC900 BIKE COMPUTER
E
Charging port
General operation of the electrical assi󰄋ance
The power assi󰘵ed bike can be used with or without assi󰘵ance by pressing the Command button «C» and altering the modes 0-1-2-3. The selec-
table 0-1-2-3 assi󰘵ance modes selectable on the «C» Command button allow you to choose a power assi󰘵 level in addition to the e󰘯ort provided.
Power assi󰘵ance will only work if you are pedalling, with a selected mode other than 0. Assi󰘵ance cuts o󰘯 when the speed is above 25km/h. In
case of intensive use and in exceptional climatic conditions, assi󰘵ance may be cut o󰘯 to safeguard the whole sy󰘵em.
The power supplied is calculated by the controller «C» based on your pedalling and the assi󰘵ance mode selected.
The motor hub «B» will provide more or less power depending on the mode selected and the force applied
Power assi󰘵ance does not kick in or shuts down in the following situations:
- The speed is above 25km/h
- You’re not pedalling
- The battery «A» remaining charge is not su󰘲cient
- «0» is the power assi󰘵ance mode selected
- When the control button is switched o󰘯
B
D
C
E
A