Vanguard Instruments LTCA-10 - 4 Pre-Test Setup; Operating Voltages; LTCA-10;40 LCD Contrast Control; LTCA-10;40 Printer Paper Control

LTCA-10/LTCA-40 USER’S MANUAL
14
4.0 PRE-TEST SETUP
4.1 Operating Voltages
The LTCA-10/40’s operating voltages are 100-240 Vac and 50/60 Hz.
4.2 LTCA-10/40 LCD Contrast Control
To increase the LCD screen contrast, press and hold the [PAPER ∧ Contrast] key for two
seconds.
To decrease the LCD screen contrast, press and hold the [PAPER ∨ Contrast] key for two
seconds.
4.3 LTCA-10/40 Printer Paper Control
To advance the LTCA-10/40 printer paper, press and release the
[PAPER ∧ Contrast] key.
To retract the LTCA-10/40 printer paper, press and release the
[PAPER ∨ Contrast] key.
4.4 LTCA-10/40 Printer Paper
The LTCA-10/40’s built-in thermal printer uses 4.5-inch wide thermal paper for printing test
results. To maintain the highest print quality and to avoid paper jams, the use of thermal paper
supplied by Vanguard Instruments Company is highly recommended. Additional paper can be
ordered from the following sources:
Vanguard Instruments Co, Inc.
1520 S. Hellman Avenue
Ontario, CA 91761
Tel: 909-923-9390
Fax: 909-923-9391
Part Number: VIC TP-4 paper
BG Instrument Co.
13607 E. Trent Avenue
Spokane, WA 99216
Tel: 509-893-9881
Fax: 509-893-9803
Part Number: VIC TP-4 paper