Vanguard Instruments LTCA-10 - Restoring a Test Record

LTCA-10/LTCA-40 USER’S MANUAL
47
5.8.2. Restoring a Test Record
Use the following steps to restore a test record from the LTCA-10/40’s Flash EEPROM to the
unit’s working memory.
a. Start from the “START-UP” menu:
Press the [2] key (SETUP).
b. The following menu will be displayed:
Press the [3] key (SAVE/RESTORE RECORD)
c. The following menu will be displayed:
Press the [1] key (RESTORE RECORD)
d. The “RESTORE RECORD” menu will be displayed:
1. ENTER RECORD NUMBER
Press the
[1] key if you know the record number. The following screen will be
displayed:
Enter the record number using the LTCA-10/40’s keypad, and then press the
[ENTER] key. “The RESTORING RECORD” screen will be displayed
momentarily:
Continue to step e.
RESTORING RECORD
RESTORE RECORD
NUMBER:
RESTORE RECORD
1. ENTER RECORD NUMBER
2. SCROLL TO SELECT
1. RESTORE RECORD
2. SAVE RECORD
3. RECORD DIRECTORY
4. ERASE RECORD
1. ENTER XFMR ID
2. PRINT RECORD
3. SAVE/RESTORE RECORD
4. SET TIME
5. SET FONT
1. TEST XFMR 03/04/09
2. SETUP 09:28:03
3. USER DIAG