INSTALLATION : INSTALLATION PROCEDURES
2
02.9663.0001 B 11-Jun-02 21
To hang luminaire in truss:
Step 1. Lift luminaire into mounting position.
Step 2. Secure in place with truss hooks. Ensure truss hook hardware that locks
hook in place (e.g. wing bolt) is properly tightened and that luminaire is fully
supported.
Step 3. Attach safety cable (as required) as follows:
a. Connect end of cable to mounting pin at one side of pan tube base.
b. Loop at least once around pipe and attach other end at second mounting
pin.
Step 4. Connect power and data cables according to procedure given in “Connecting
Data and Power” on page 24.
Figure 2-7: Example Luminaire Truss Hanging Installation
26"
(66cm)
26.5"
(67.3cm)
34.5"
(87.6cm)
17.5"
(44.5cm)
Safety Cable:
Recommended for all
hanging installations.
May be required by
local codes.
To Next Page
Loading...
