INSTALLATION : ADDRESSING
2
02.9663.0001 B 11-Jun-02 29
Addressing
Program Starting Address
The DMX starting address is entered using the Menu Display. This address will be
retained even if the power is removed.
Note: Refer to Chapter 4: Menu System for detailed instructions on menu functions.
Note: Refer to your console operating instructions for specific information regarding
its addressing requirements.
To program a DMX starting address:
Step 1. Press [Menu].
Step 2. Press [Up] / [Down] arrows until Address appears. Press [Enter].
Step 3. DMX will appear. Press [Enter].
Step 4. Press [Up] / [Down] arrows to enter starting address.
Step 5. Press [Enter] to set.
Program Starting Address Without Calibrating
It is possible to bypass the calibration sequence and go directly to the Menu Display
programming in order to pre-program an address setting.
To program starting address without calibrating luminaire:
• While powering up luminaire, press and hold [Menu]. Program address as in
Program Starting Address above.
Note: The luminaire will require a reset to restore control.
To Next Page
Loading...