Vatech EzSensor

2. Hardware Installation
2.4. Installation of the EzSensor Holder
The EzSensor holder is used for mounting the EzSensor to the wall when it is not in use.
When choosing where to install the EzSensor, locate an area that offers easy access and visibility during
patient examination.
① Position the holder on a stable, flat surface. Using the holes at the back of the holder as guides,
fasten the holder securely to the wall using 2 dry wall screws (included).
② Remove the tape from the backside of the silicon holder. Attach the silicon holder to the sensor holder.
19