How to fix Vatech PaX-500 Dental equipment if it is not moving?
If your Vatech Dental equipment isn't moving, first, ensure the device is powered on. Then, verify that the device has completed its initialization process. Finally, check the connection of the Serial Port (RS232) linking the PC and the device.
What to do if imaging is not working on Vatech PaX-500 Dental equipment?
If imaging is not working on your Vatech Dental equipment, allow the device to complete its initialization. If the problem persists, power the device off, and then restart it.
Why is the exposure switch not working on my Vatech PaX-500?
If the exposure switch isn't working on your Vatech Dental equipment, ensure that the imaging program indicates that the system is ready for capturing.
What to do if the laser beam is off on Vatech PaX-500?
If the Laser Beam is off, preventing patient alignment on your Vatech Dental equipment, press the LAMP Button to enable the laser and proceed with patient alignment.
Lists key benefits like reduced X-ray dose, user-friendly operation, high-definition sensor, and diverse imaging modes.
Details hardware (main frame, accessories) and software (viewer, imaging programs) components of the system.
Provides essential safety instructions for operation, checking status, and handling potential malfunctions.
Specifies rules for radiation safety, including personal protective gear and distance requirements for users.
Outlines conditions for manufacturer/seller responsibility regarding product safety and operation.
Describes physical parts like sensor modules, holders, chinrest, and LED lamps for system operation.
Explains the menu structure and interface of the imaging software program.
Details the main screen, mode screen, and setting screens of the LCD panel for imaging operations.
Covers essential pre-imaging steps like powering on the equipment and checking PC status.
Provides step-by-step guidance on positioning patients for panoramic and cephalometric imaging using laser beams.
Explains how to register patients and execute panoramic/cephalometric imaging procedures.
Offers solutions for common issues like device movement, exposure switch, and laser beam problems.
General| Imaging Modes | Panoramic, Cephalometric |
|---|---|
| Focal Spot Size | 0.5mm |
| Tube Current | 2-10 mA |
| X-ray Tube Current | 2-10 mA |
| Power Requirements | 220V, 50/60Hz |
| Tube Voltage | 60-86 kVp |
| X-ray Tube Voltage | 60-86 kVp |
To Next Page