VATECH Co., Ltd.
Release
V2.0.0
PaX-500
26
1. Preparation before Imaging
Make sure to check the following before starting imaging.
● Start your PC after turning on the power of the equipment.
● Check whether the equipment is turned on.
● Do not perform any operation of PC while the product is in operation.
● Check whether there is any problem in operation of PC.
When the equipment is already turned on, select the Imaging Mode through
imaging program and then follow the instruction of the program.
This configuration may differ depending on specification of your product. Check
the production information of appendix for details of manual.
To Next Page
Loading...
