PaX-i3D Green (PHT-60CFO) User Manual
159
Appendices
NOTE 1) At 80MHz and 800MHz, the higher frequency range applies.
NOTE 2) These guidelines may not apply in all situations. Electromagnetic
propagation is affected by absorption and reection from structures, objects,
and people.
a
Field strengths from fixed transmitters, such as base stations for radio
(cellular/cordless) telephones and land mobile radios, amateur radio, AM
and FM radio broadcast, and TV broadcast cannot be predicted theoretically
with accuracy. To assess the electromagnetic environment due to xed RF
transmitters, an electromagnetic site survey should be considered. If the
measured eld strength in the location where the PaX-i3D Green (Model:
PHT-60CFO) is used exceeds the applicable RF compliance level above,
the PaX-i3D Green (Model: PHT-60CFO) should be observed to verify
normal operation. If abnormal performance is observed, additional measures
may be necessary, such as re-orienting or relocating the PaX-i3D Green
(Model: PHT-60CFO)
b
Over the frequency range 150kHz to 80MHz, eld strengths should be less
than [V
1
] V/m.
Recommended separation distances between portable and mobile RF
communications equipment and the PaX-i3D Green (Model: PHT-60CFO)
This is intended for use in an electromagnetic environment in which radiated
RF disturbances are controlled. The customer or the user of the PaX-i3D
Green (Model: PHT-60CFO) can help Prevent electromagnetic interference
by maintaining a minimum distance between portable and mobile RF
communications equipment (transmitters) and the PaX-i3D Green (Model:
PHT-60CFO) as recommended below, according to the maximum output
power of the communications equipment.
[PI3DG_130U_44A_en]User Guide.indd 159 2016-05-24 오후 4:19:24
To Next Page
Loading...
