In case of emergency
Hazard warning flashers................... 142
Assist and SOS.................................
142
Emergency call...............................142
Automatic SOS...............................143
Warning triangle................................143
Jacking the vehicle and wheel
changing........................................... 144
List of tools..................................... 145
Spare wheel................................... 146
Removing a wheel..........................146
Tyre repair kit....................................148
Checking/adjusting tyre
pressures........................................151
Jump starting.................................... 152
Hazard warning flashers
Operated by pressing
When braking in an emergency, the
hazard warning flashers are switched on
automatically, depending on the force
of deceleration. They are switched off
automatically, as soon as the vehicle is
accelerated again.
Assist and SOS
Emergency Call
Note
In order to be available and operational,
the system requires functioning vehicle
electrics, mobile service and GPS or
GLONASS satellite link. Depending on
equipment, a backup battery is used.
Note
The service is only available for markets
where it is legally required.
Furthermore, it depends on the
availability of the emergency centres and
on the infrastructure in the country.
Status LED in the overhead console
Illuminates green and red and
extinguishes after a short time, when the
ignition is switched on: the system works
properly.
Illuminates red: fault in the system.
Contact a workshop.
Flashes red: backup battery needs
replacement. Contact a workshop.
Emergency call
The emergency call function will establish
a connection to the nearest public safety
answering point (PSAP).
A minimum set of data including vehicle
and location information will be sent to
the PSAP.
In case of an emergency, press the red
SOS button in the overhead console for
more than two seconds.
142
In case of emergency
To Next Page
Loading...
