Note
The temperature preconditioning is only
activated if the ignition is off and the
vehicle is locked.
If the charging level of the high voltage
battery is below 30%, the temperature
preconditioning is not activated.
When the vehicle is plugged in, battery
charging takes precedence over pre-
conditioning.
Consequently, it can only be activated if
the battery is charged above a threshold
fixed at 80%.
If a recurrent heating / ventilation is
programmed and two heating / ventilation
procedures are carried out without
operating the vehicle, the programming is
deactivated.
Setting timer
Note
Several timers can be programmed and
saved. It is recommended to program
temperature preconditioning with the
vehicle plugged in, in order to optimise
the long-term performance of the high
voltage battery.
Press
MENU.
Touch OPTIONS.
Select .
Touch
+ to define a new timer.
Touch --:--.
Enter time and day.
Press
to confirm the settings.
Press
ON to activate the timer.
To delete a timer, press at the top
of the Information Display and delete the
desired timer.
Confirm the deletion.
The heating / ventilation procedure
starts approx. 45 minutes before the
programmed time when the vehicle is
plugged in, or 20 minutes before the
programmed time when it is not plugged
in, and is maintained ten minutes after it.
Adjustable Air Vents
Air vents in the instrument panel
Direct the flow of air by tilting and
swivelling the slats.
To close the vent, swivel the slats
inwards.
Dashboard instruments and controls
67
To Next Page
Loading...
