To select the respective drive mode, use
the shown toggle switch.
Normal mode
The settings in this mode are set
by default. Every time the ignition is
switched on, this mode is selected.
BEV: To optimise range, electric engine
power output is reduced.
Sport mode
The settings in this mode allow more
dynamic driving. The vehicle's dynamic
parameters can be displayed on the
cluster.
BEV: This mode allows maximum electric
engine power output.
Eco mode
Reduces fuel consumption by optimising
the operation of the heating and air
conditioning and, depending on the
version, the accelerator pedal, the
automatic transmission and the gear
shifting indicator.
While coasting the vehicle, the engine is
idling with reduced engine brake.
BEV: To optimise range, electric engine
power output and heating are reduced.
Propulsion types ð
page 3
Engine exhaust
DANGER
Engine exhaust gases contain
poisonous carbon monoxide, which is
colourless and odourless and could be
fatal if inhaled.
If exhaust gases enter the interior of the
vehicle, open the windows.
Have the cause of the fault rectified by
a workshop.
Avoid driving with an open load
compartment, otherwise exhaust gases
could enter the vehicle.
Exhaust filter
Automatic cleaning process
The exhaust filter system filters soot
particles out of the exhaust gases.
The start of saturation of the exhaust
filter is indicated by the temporary
illumination of or , accompanied
by a message on the cluster.
Start cleaning process as soon as
possible by driving at a vehicle speed of
at least 40 mph.
Note
On a new vehicle, the first exhaust
filter regeneration operations may be
accompanied by a burning smell, which
is normal. Following prolonged operation
of the vehicle at very low speed or at
idle, water vapour can be emitted at the
exhaust on acceleration. This does not
affect the behaviour of the vehicle or the
environment.
Cleaning process not possible
If
or
stays on, accompanied by
an audible signal and a message, this
indicates that the exhaust filter additive
level is too low.
The reservoir must be topped-up without
delay. Seek the assistance of a
workshop.
Starting and operating
91
To Next Page
Loading...
