The brake fluid should therefore be
replaced at the specified interval.
Use only brake fluid approved for the
vehicle. Consult a workshop.
Coolant And Antifreeze
Use only antifreeze approved for the
vehicle. Consult a workshop.
The system is factory-filled with
coolant designed for excellent corrosion
protection and frost protection down to
approx. -28 °C. In cold regions with
very low temperatures, the factory filled
coolant provides frost protection down to
approx. -37 °C. This concentration should
be maintained all year round.
The use of additional coolant additives
that intend to give additional corrosion
protection or seal against minor leaks
can cause function problems. Liability
for consequences resulting from the use
of additional coolant additives will be
rejected.
Wiper Blade Replacement
Windscreen
Switch off ignition.
Within one minute after switching off
ignition, operate the wiper lever to
position the wiper blades vertically on the
windscreen.
Lift the wiper arm until it stays in
the raised position, press button to
disengage the wiper blade and remove.
Attach the new wiper blade to the wiper
arm and push until it engages.
Lower wiper arm carefully.
To return the wiper arms to their original
position, switch on the ignition and
operate the wiper lever.
Rear window
Lift wiper arm. Disengage wiper blade as
shown in illustration and remove.
Attach the wiper blade slightly angled to
the wiper arm and push until it engages.
Lower wiper arm carefully.
Electrical system
Fuses
A defective fuse must be replaced by a
workshop.
Bulb replacement
Exterior lights are designed as LEDs and
cannot be changed.
164
Maintenance and vehicle care
To Next Page
Loading...
