between daytime running lights and
headlights automatically depending on
the external lighting conditions and
information given by the wiper system.
Daytime running light ð
page 39
Automatic headlight activation
Turn the switch in position: AUTO
During poor lighting conditions the
headlights are switched on.
Additionally, headlights are switched on
if the windscreen wipers have been
activated for several wipes.
Tunnel detection
When a tunnel is entered, headlights are
switched on immediately.
Headlight Beam Adjustment
To activate or deactivate the high beam,
pull the lever beyond the resistance
point.
High beam assist
The system switches from low beam to
high beam and vice versa to prevent
glaring. Once activated, high beam assist
remains active and switches high beam
on and off depending on surrounding
conditions. The latest setting of the high
beam assist will remain after the ignition
is switched on again.
Glare-free high beam for Matrix-LED
headlights ð
page 38
Activation
The high beam assist can be activated
via the vehicle settings menu in the
Information Display.
Information Display ð page
68
High beam is switched on automatically
in dark surroundings at a speed above
28 mph. High beam is switched off at
a speed below 22 mph, but high beam
assist remains active.
The green control indicator
illuminates continuously when the high
beam assist is activated, the blue
illuminates when high beam is on.
Control indicator ,
.
High beam assist switches automatically
to low beam when:
● Driving in urban areas.
● Camera detects heavy fog.
● Rear fog light is switched on.
● Oncoming or preceding vehicles are
detected by the camera.
If there are no restrictions detected, the
system switches back to high beam.
Deactivation
The system can be deactivated via the
vehicle settings menu in the Information
Display.
Information Display ð
page 68
Headlight range adjustment
To adapt headlight range manually to
the vehicle load to prevent dazzling, turn
thumb wheel to required position.
40
Getting to know your vehicle