Warning
Do not drive faster than 50 mph. Do not
use for a lengthy period. Steering and
handling may be affected.
In the case of a flat tyre:
Apply the parking brake and engage first
gear, reverse gear or P
.
The tyre repair kit is in the load
compartment below the floor cover.
1. Remove the sealant bottle and the
compressor.
2. Pull the speed-limit label from the
sealant bottle and place it in driver's
visible area.
3.
Remove the electric connection cable
(1) and air hose (2) from the stowage
compartments on the underside of the
compressor.
4.
Open the sealant bottle and lift the lid.
5.
First, insert the sealant bottle into
the compressor and align the triangle
symbols. Then, push down the
sealant bottle and turn it to the lock
position.
6.
Set the compressor near the tyre in
such a way that the sealant bottle is
upright.
7.
Unscrew the valve cap from the
defective tyre.
8.
Screw the filler hose to the tyre valve.
9. The switch on the compressor must
be set to O.
In case of emergency
149
To Next Page
Loading...
