Lead connection order:
1. Connect the red lead to the positive
terminal of the booster battery.
2. Connect the other end of the red
lead to the positive terminal of the
discharged battery.
3.
Connect the black lead to the
negative terminal of the booster
battery.
4. Connect the other end of the
black lead to a vehicle grounding
point of your vehicle in the engine
compartment.
Route the leads so that they cannot
catch on rotating parts in the engine
compartment.
To start the engine:
1. Start the engine of the vehicle
providing the jump.
2. After five minutes, start the other
engine. Start attempts should be
made for no longer than 15 seconds
at an interval of one minute.
3.
Allow both engines to idle for
approx. three minutes with the leads
connected.
4. Switch on electrical consumers e.g.
headlights, heated rear window.
5. Reverse above sequence exactly
when removing leads.
In case of emergency 153
To Next Page
Loading...
