Gear selector
Move the selector or press the respective
buttons.
P : park mode
R : reverse mode
N : neutral mode
D : automatic mode
M : manual mode
After moving the selector it returns to the
centre position. The engaged mode is
indicated on the cluster.
Moving the selector beyond the
resistance point skips neutral mode N.
Never depress the accelerator pedal and
brake pedal at the same time.
When D or R is engaged, the vehicle
slowly begins to creep when the brake is
released.
Park mode P
To engage P, press button P when
vehicle is stationary. In P, the front
wheels of the vehicle are blocked.
To disengage P, depress the brake pedal
and select the desired mode.
P is automatically engaged when
● the ignition is switched off
● the driver's door is opened while the
vehicle's speed is below 1 mph
● N has been selected for some time
If the vehicle is moving too fast, P is not
engaged.
Reverse mode R
To engage or disengage R, the vehicle
must be at standstill and the brake pedal
must be depressed.
CAUTION
Engaging R
while the vehicle is moving
forward could damage the automatic
transmission. Only select R after the
vehicle has stopped.
Neutral mode N
In this mode, the propulsion system does
not transfer torque to the wheels.
Automatic mode D
Note
In slippery conditions, operate the vehicle
in D for enhanced riding and handling
performance.
This mode is for normal driving.
Manual mode M
In this mode, it is possible to change
gears manually using the steering wheel
paddles.
Manual mode M can only be selected if D
is engaged.
The selected gear is indicated on the
cluster.
If a higher gear is selected when vehicle
speed is too low, or a lower gear when
vehicle speed is too high, the shift is not
executed. This can cause a message on
the cluster.
In manual mode, no automatic shifting to
a higher gear takes place at high engine
revolutions.
Press button M.
88
Starting and operating
To Next Page
Loading...
