Warning! Some vehicle modifica-
tions may have no coolant level indi-
cator.
4 — door ajar LED.
Lights up in red when a door is ajar.
5 — stoplight or side-marker
lights failure LED.
If the stoplight bulb is faulty the LED
lights up in orange when the brake
pedal is depressed. Also lights up if a
faulty side-marker bulb is activated.
6 — front brake pad wear indica-
tor.
Lights up in orange when the brake
pedal is depressed if the brake lining
thickness is reduced to 1.5 mm. Goes
off at ignition switch-off.
7 — seat belt reminder LED.
Optional. Lights up in red if the dri-
ver’s seat belt is not fastened.
Modes of control module
The control module has the follow-
ing modes:
— OFF;
— stand-by;
— start-up functional check;
— parameter check.
The module is OFF if there is no key
in the ignition switch. With the ignition
key in the «0» (OFF) position the mod-
ule enters the stand-by mode. If the dri-
ver’s door is open, «Key left in the igni-
tion lock» error is generated and an
intermittent beep sound is heard for
about 5-7 seconds. To stop beeping,
close the door, remove the key or turn
it to position «I» (Ignition). With the key
in this position, the module enters
«Start-up functional check» mode. In
this mode all the visual and sound
alarms are activated for 3-5 seconds.
Then, after a second’s pause, the mod-
ule enters «Parameter check» mode
and in the event of any failures, the
alarm is indicated as follows:
— LED of the failed parameter flash-
es for 5-7 seconds, then illuminates
continuously until the problem is fixed
or the ignition key is returned to posi-
tion «0» (OFF);
— Beep sound for 3 seconds (simul-
taneously with the LED);
— if another problem occurs at the
same time, the latest problem will have
higher priority and its LED will start
flashing and a beep will be heard, the
LED of the previous fault illuminates
continuously.
Important!
The on-board control system displays
oil level with a 10 minute delay. This
delay is activated after the engine is
stopped if the ignition key remains in the
19
Fig. 21. On-board control system display
To Next Page
Loading...
