VDO MS 5400 - Calling; Volume of Call; Dialling; Dialling Via Numeric Buttons

Calling
Volume of call
During a phone call, the volume can be adjusted via the + or - buttons on
the remote control. The last setting selected is stored. Alternatively, the
volume can be adjusted on the mobile phone itself. The ring volume for
an incoming call can be lowered or increased.
Dialling
Phone numbers to be dialled can be
•
entered directly,
•
selected from call lists
•
selected from the “Navigation” menu (destination phone number,
where available)
•
selected from the list of points of interest (POI browser), if a phone
number is provided
•
selected from the phone book of the SIM card and the phone memory.
Dialling via numeric buttons
u
Enter the desired phone number in the “Phone” menu via the
virtual keypad. Once a button has been highlighted with the
cursor and the OK button pressed to confirm the selection, the
digit will be shown in the right-hand display zone.
u
Once entry of the desired phone number is complete, press the
green handset button and confirm with OK. The connection is
established. Pressing the red handset button terminates the
connection.
Call list
Call numbers can also be selected for dialling directly from the following
lists in the phone menu: “Missed calls”*, “Incoming calls” *, “Outgoing
calls”
* depending on the network operator. The function for caller
identification must be supported.
To select a phone number from the call lists:
u
Select the folder in the “Telephone” menu and press the OK
button.
u
Select “Call register” and confirm with the OK button.
u
Select the desired list and press the OK button.
u
Select the desired entry and press the OK button. The selected
phone number appears in the display field.
u
The connection can be initiated by pressing the green handset
button.
54
TELEPHONE