Do you have a question about the Veco CLIMMA COMPACT MK3 and is the answer not in the manual?
Brand | Veco |
---|---|
Model | CLIMMA COMPACT MK3 |
Category | Air Conditioner |
Language | English |
Read carefully this manual before using the system. Use the air-conditioner only for its intended purpose.
Explains how the refrigerating circuit works in cooling and heat modes, and the EH version.
Details the buttons and functions of the VEGA MK3 control panel, including display and knobs.
Describes how the AUTO mode automatically selects cooling or heating based on room temperature.
Explains AUTO, Dehumidify (D), Automatic Special (AF), and Fan Only (FO) modes.
Describes the automatic antifreeze function activated by the optional temperature sensor.
Explains how the display and LEDs dim automatically based on ambient light.
Explains the compressor status indicator and HP alarm message.
Details the option for an additional remote sensor to override the standard one.
Explains the ON/OFF, MODE, FAN, and TEMP settings via buttons and display.
Details the functions of buttons 1 through 7 on the VEGA MKII infrared remote control.
Safety precautions for installing the split system compressor in the engine room, preventing explosions.
Emphasizes that only qualified engineers should troubleshoot the system, respecting safety rules.
For systems with multiple compressors, set a 5-second time delay between each.
Check for leaks or obstructions on condensate drains and ensure regular drainage.
Periodically clean or replace the air filter to prevent obstruction and maintain efficiency.
Periodically clean the water strainer to ensure proper pump and cooling circuit function.
Instructions for draining water from the system when the boat is not used below 0°C.
Each product is identified by a label; refer to part/serial number for service.
Check circuit breaker, reset if tripped. Check fuse F1 if fan doesn't turn.
Check mode, thermostat, fan speed, air circulation, and air filter.
Check mode, thermostat, fan speed, and air circulation for RC models.
Check mode, thermostat, fan speed, and air filter for EH models.
Check fuse F1 and the high pressure switch device.
Manufacturer declares product conformity to specified directives and standards.