Vector CANcaseXL - 2.4.2 Additional LEDs

Manual CANcaseXL and CANcaseXL log
© Vector Informatik GmbH Version 4.0 - 11 -
2.4.2 Additional LEDs
Additional LEDs on
CANcaseXL log
The CANcaseXL log contains beside the LEDs Tx, Rx and Err the LEDs Status and
Data with the following meaning:
Status Data Meaning
off off
Device is not operating.
Device is in Interface Mode without SD card.
green * Device is in Interface Mode with a valid SD card.
red * Device is in Interface Mode with an invalid SD card.
orange orange Device is booting in Logger Mode.
green off Device is waiting for a SD card.
green (( green )) Device is accessing the SD card.
((green)) *
Device is ready for logging.
Device is waiting for trigger.
((red)) off Device reports an error and stops logging.
(( orange )) *
Warning: SD card contains less than 10% of free space.
Logging is not stopped.
* (( orange ))
Warning: Critical data rate, but messages are not lost.
Logging is not stopped. LED state will change when
critical data rate decreases.
* (( red ))
Error: To high data rate, messages are lost. Logging is
not stopped but LED state will not change till device is
rebooted.
* : Alternating state of the LED, depending on data transmission.
(( )) : Blinking or flashing LED.