CANcaseXL and CANcaseXL log Manual
- 12 - Version 4.0 © Vector Informatik GmbH
2.4.3 Piezo buzzer
Trigger event signals The CANcaseXL log has a piezo buzzer that acoustically alerts the user to internal
trigger events. Triggers may be defined using the
XL log Config configuration tool
(see installation CD
\Drivers\CANcaseXL\Tools\XL_log_Config_Users
Guide.pdf
).
2.4.4 Memory card
Inserting and
removing of SD card
The CANcaseXL log has a push-and-pull card holder in which the SD card is inserted
and removed. To insert a SD card push it until it latches in place securely. To remove
the SD card push it into the holder slot a little bit until it unlatches then let it go and it
will spring out of its latched position.
Warning: Do not pull the SD card from the card holder forcefully, since this could
cause mechanical damage!
Formatting SD card Before using the SD card it has to be formatted with the configuration tool
XL log
Config
, see manual \Drivers\CANcaseXL\Tools\XL_log_Config_Users
Guide.pdf
.
Memory
requirements
A single CAN message needs up to 20 byte, a single LIN message needs up to 108
bytes on the memory card.
CardFix Kit The standard delivery of the CANcaseXL log allows the user to insert and remove the
SD card from outside. In some situations, e.g. to prevent thefts, the inserted SD card
shall not be removable. The
CardFix Kit is a good protection, because the back side
plate with the SD card slot is replaced by a closed plate. Thus the SD card cannot be
removed so easily anymore. The
CardFix Kit can be ordered at Vector (article number
07132).
Warning: The CANcaseXL log must be opened for this modification! A detailed
instruction is delivered with the kit. However, the modification of your CANcaseXL log
can be done by our service.
2.4.5 Battery
Lifetime The CANcaseXL log is supplied with a lithium battery that has a typical durability of 5
years. It is responsible for correct timing of the integrated clock.
To Next Page
Loading...