Windows 2000 Manual
- 18 - Version 1.3 © Vector Informatik GmbH
3.3 Checking driver installation
1. Start the Device Manager.
2. Check to see whether the device is shown in the group CAN-Hardware and
Vector-Hardware respectively.
3. Verify the proper installation by double clicking the device item. After successful
installation of the driver switch to the General tab and you will see the device
status This device is working properly.
Device properties
4.
If the device causes a conflict refer to the detailed instructions in section
Checking installation on page 46.
5. Verify the successful hardware installation as described in the installation
instructions for your application. A hardware test may also be performed
independently of your application. This is described in section Loop test on page
42.
To Next Page
Loading...