Manual Introduction
© Vector Informatik GmbH Version 4.0 - 5 -
1.1.2 Certification
Certified Quality
Management System
Vector Informatik GmbH has ISO 9001:2000 certification. The ISO standard is a
globally recognized standard.
1.1.3 Warranty
Restriction of
warranty
We reserve the right to change the contents of the documentation and the software
without notice. Vector Informatik GmbH assumes no liability for correct contents or
damages which are resulted from the usage of the user manual. We are grateful for
references to mistakes or for suggestions for improvement to be able to offer you
even more efficient products in the future.
1.1.4 Support
You need support? You can get through to our support at the phone number
+49 711 80670-200 or by fax
+49 711 80670-111
E-Mail: support@vector-informatik.de
1.1.5 Registered trademarks
Registered
trademarks
All trademarks mentioned in this user manual and if necessary third party registered
are absolutely subject to the conditions of each valid label right and the rights of
particular registered proprietor. All trademarks, trade names or company names are
or can be trademarks or registered trademarks of their particular proprietors. All rights
which are not expressly allowed, are reserved. If an explicit label of trademarks,
which are used in this user manual, fails, should not mean that a name is free of third
party rights.
¼
Windows, Windows 2000, Windows XP, Windows Vista are trademarks of the
Microsoft Corporation.
To Next Page
Loading...