Operating test and troubleshooting Manual
- 44 - Version 1.3 © Vector Informatik GmbH
6.1.2 FlexRay
Device test The operating test for FlexRay can be executed with the following devices:
¼ VN3300
¼ VN3600
¼ VN7600
FRLoop.exe This operating test requires a FlexRay Interface with a FRpiggy, which is plugged to
the PC and installed. Remove the FlexRay cable if plugged.
1. Start the
FRLoop.exe program from the driver directory on the Installation CD.
2. Execute the test.
3. If no error messages occur, the operating test was successful.
Note: If the functional test could not be performed successfully, please refer to
section Checking installation on page 46.
To Next Page
Loading...