Veeder-Root TLS2 - Page 162

Serial Interface Manual
• TLS2 Monitoring Systems
Part No. 577013-767, Revision H 159
IN-TANK SETUP (7.3.4) (Continued)
Code Ver Function
624 1 Set Tank High Water Level Limit
628 1 Set Tank Maximum Volume Limit
629 1 Set Tank Delivery Required Limit
62A 1 Set Tank Annual Leak Test Minimum Volume
62D 1 Set Enable/Disable Tank Leak Test Fail Alarms
62F 1 Set Mag Probe Float Size
633 1 Set Leak Test Report Type
636 1 Set Tank Periodic Leak Test Minimum Volume
638 1 Set Tank Overfill by Percent
641 5 Set Density Code
644 6 Set Tank Density Float Serial Number
645 6 Set Tank GOST Volume Correction Enable
647 6 Set Tank Multipoint Chart Profile
671 5 Set Tank Density High Limit
672 5 Set Tank Density Low Limit
MISCELLANEOUS SETUP (7.3.5)
Code Ver Function
854 1 Set Immediate Non-volatile RAM Store
881 1 Set Communication Port Data
882 1 Initialize Communication Port Data
883 1 Set Serial Communication Language
884 1 Set Serial Handshaking Method
885 1 Set Modem Type
886 1 Set Modem Dial-In Setup String
88A 1 Set Communications Port Type
88B 1 Set Printer Language
88C 1 Set Modem Dial-Out Setup String
893 4 Acknowledge Tank Event Ready Status
8C0 4 TCP/IP Parameter Inquiry
8C1 4 Set TCP/IP Host Address
8C2 4 Set TCP/IP Gateway IP Address
8C3 4 Set TCP/IP Subnet Mask Address
8C4 4 Set TCP/IP Host Port Number
8C5 4 Set TCP/IP Remote IP Address
8C6 4 Set TCP/IP Remote Port Number
8C7 4 Set Email Recipient 1