Serial Interface Manual
• TLS2 Monitoring Systems
Part No. 577013-767, Revision H 158
COMMUNICATIONS SETUP (7.3.2) (Continued)
Code Ver Function
536 1 Set RS-232 Security Code per Port
539 4 Set Receiver Auto Dial On Events
545 5 Set TC Density Enable
54D 4 Set IS03166 3 Character Country Code
I/O DEVICE SETUP (7.3.3)
Code Ver Function
55C 1 Set Relay Alarm Assignment
56B 4 Set Autodial Confirmation Flag
56D 4 Set Shift Close Method
56E 4 Set Manual Close Timeout
571 4 Set Dial Type
574 5 Set Push Site ID Enable
575 5 Set Dial Type
577 4 Set Inventory Start Time
578 4 Set Inventory Repeat Interval
579 5 Set Tank Idle Delivery Enabled
IN-TANK SETUP (7.3.4)
Code Ver Function
601 1 Set Tank Configuration
602 1 Set Tank Product Label
604 1 Set Tank 1 Point Full Height Volume
605 1 Set Tank 4 Point Full, 3/4, 1/2, 1/4 Volumes
606 1 Set Tank 20 Point Full, 95%, 90%,...Volumes
607 1 Set Tank Diameter
608 1 Set Tank Tilt
609 1 Set Tank Thermal Expansion Coefficient
60A 1 Set Tank Linear Calculated Full Volume
60B 1 Set Tank Stick Height Function Enable
60C 1 Set Tank Stick Height Offset
60D 1 Set Chinese Fixed Product Label
610 1 Set Tank Delivery Delay
611 1 Set Tank Leak Test Type & Start Time
612 1 Set Tank Manifolded Partners
61A 1 Set In-Tank Leak Test Early Stop
621 1 Set Tank Low Level Limit
623 1 Set Tank Overfill Level Limit
To Next Page
Loading...
