Vega MINITRAC 31 - Page 57

57
6Setupwiththedisplayandadjustmentmodule
MINITRAC 31 • Foundation Fieldbus
41782-EN-211203
Menu Menu item Default value
Setup Measurement loop name Sensor
Isotope Cs-137
Application Limit level
Adjustment mode Single point adjustment
Adjustment - uncovered 90000ct/s
Adjustment - covered 9000ct/s
onlywithtwo-pointadjustment
Delta I 90 %
Background radiation 0ct/s
Temperature unit ° C
Adjustment mode 1-point
Adjustment uncovered 900000ct/s
Delta I 90 %
Mode - Relay Overllprotection
Lock adjustment Released
Display Language Selected language
Displayed value Pulse rate
Display unit ct/s
With this function
•
Load parameter adjustment data from the sensor into the display
and adjustment module
•
Write parameter adjustment data from the display and adjustment
module into the sensor
The copied data are permanently saved in an EEPROM memory in
the display and adjustment module and remain there even in case of
apowerfailure.Fromthere,theycanbewrittenintooneormoresen-
sors or kept as backup for a possible sensor exchange.
Note:
Before the data are copied into the sensor, a check is carried out to
determineifthedatatthesensor.Ifthedatadonott,afaultsignal
istriggered.Whendataarebeingwrittenintothesensor,thedisplay
showswhichinstrumenttypethedataoriginatefromandwhichTAG
number this sensor had.
6.5.5 Info
Inthismenuyouwillndthefollowingmenuitems:
•
Instrumentname-showsinstrumentnameandserialnumber
Copy instrument settings
Info