Vega VEGAPULS 31 - Page 14

14
4 Mounting
VEGAPULS 31 • Two-wire 4 … 20 mA/HART
57820-EN-191014
> 200 mm
(7.87
")
Fig. 7: Mounting of the radar sensor on round vessel tops
In vessels with conical bottom it can be advantageous to mount the
sensor in the centre of the vessel, as measurement is then possible
down to the bottom.
Fig. 8: Mounting of the radar sensor on vessels with conical bottom
Donotmounttheinstrumentsinorabovethellingstream.Makesure
thatyoudetecttheproductsurface,nottheinowingproduct.
Fig.9:Mountingoftheradarsensorwithinowingmedium
With threaded connection, the antenna end should protrude at least
5 mm (0.2 in) out of the socket.
Inowingmedium
Threaded socket und
socket piece