3578 • CB500 VENDOR | 1
INTRODUCTION
This manual contains instructions, service, and installation guidelines. Read and
follow the instructions to minimize set-up time. Become familiar with its features
and functions.
It is equipped with an electronic control system. All programming of the vend
functions, pricing and features is done on the control board. Changes can be made
without any additional accessories or remote parts.
This manual should be read
thoroughly to become familiar
with the functions and features of
the CB500. The initial set-up of a
vending machine is a very
important step of insuring that the
equipment operates in a trouble-
free manner. Following the
instructions at the initial
installation of the machine will
avoid service problems and
minimize set-up time.
MODEL & SERIAL
NUMBER
Please find the identification plate located on the backside of the cabinet and
record the Model and Serial Number of your vending machine (vendor) on the
space below.
Refer to these numbers on all correspondence and inquiries concerning this
vendor. They are needed if service and parts information is required for your
vendor.
MODEL NUMBER: ____________
SERIAL NUMBER: ____________
If you have any questions regarding the information in the manual, replacement
parts or the operation of the vendor you should contact your local distributor or
service entity.
If you have any questions pertaining to the
information in the manual, replacement parts
or the operation of the vending machine,
then you should contact your local distributor
or:
VendNet™
165 North 10
th
Street
Waukee, Iowa 50263
United States of America
Phone: (515) 274-3641
Parts Fax: (515) 987-4447
Sales Fax: (515) 274-0390
Email: vendnet@vendnetusa.com
Website: http://www.vendnetusa.com
To Next Page
Loading...