Ventacity Systems VSCM Series - 3 Upacking; Inspect Delivery; Unpack the Unit

13
Rev. 01.01
UNPACKING
3. UNPACKING
VSXXXXCMx
3.1 INSPECT DELIVERY 3.2 UNPACK THE UNIT
READ CAREFULLY!
READ CAREFULLY!
● Inspectthepackagingfordamagesimmediate-
ly upon delivery. In case of damage in the pack-
aging, notify the carrier. If a complaint is not
submitted in due time, it will be disregarded.
● Ensuretheproductcorrespondstotheorder.If
it doesn’t, do not unpack it and contact the sup-
plier immediately.
● After unpacking, check the condition of the
unit and all the components thereof. In case of
doubt, contact the supplier.
● Donotuseadamagedunit.
● Iftheunitisn’tunpackedupondelivery,storeit
indoors, in a dry place, at temperatures ranging
from +41 °F to +104 °F.
● Ifduringtransporttheunitwasexposedtotem-
peratures lower than 0 °C, leave it unpacked for
at least two hours at room temperature before
connecting it in order to level the temperature
inside the unit.
The product must be disposed
of pursuant to the local
regulations.
The product contains batteries
that must be recycled or
disposed of apart from the
common waste.
When the batteries or the
product reach the end of
their lifespan, contact the
distributor or the local
authorities for recycling.
The separate collection and
recycling of product and
batteries contribute with the
care of natural resources
and ensures that they will be
recycled in a health-conscious
and environmentally friendly
manner.
●AlltheVSCMunitsmustbeplacedhorizontally.
Any other position is forbidden.
TECHNICAL DATA
The unit must be installed so that the direction of the air
exhaust corresponds to that of the distribution system.
The unit should be installed so as to provide access for
maintenance, service or disassembly. This includes, in
particular, access to the inspection aps and their open-
ing, access to the cover of the control unit’s cabinet, to
connect side units and to the cover of the of the air lter.