Need help?Do you have a question about the Ventis MX4 and is the answer not in the manual?
General| Type | Multi-Gas Detector |
|---|---|
| Operating Temperature | -20°C to 50°C (-4°F to 122°F) |
| Gases Detected | Oxygen, Carbon Monoxide, Hydrogen Sulfide, Nitrogen Dioxide, Sulfur Dioxide, Combustible gases |
| Display | LCD |
| Ingress Protection | IP66 |
| Pump | Optional internal pump |
| Size | 103 mm x 58 mm x 30 mm (4.1 in x 2.3 in x 1.2 in) |
| Alarms | Audible, Visual, Vibrating |
| Sensors | Electrochemical, Catalytic Bead, Infrared |
| Data Logging | Yes |
| Detection Capability | Parts per million (ppm), percent by volume (% vol), percent lower explosive limit (% LEL) |
Safety guidelines, conditions of use, and agency warnings for the monitor.
Best practices for safe and effective monitor operation.
Guide to unpacking the monitor, checking contents, and initial setup procedures.
Instructions for charging the battery, powering the monitor on/off, and performing initial tests.
Detailed steps for configuring monitor settings and options.
Procedures for zeroing, calibrating, and bump testing sensors for accurate readings.
Recommended practices for air sampling and guidelines for cleaning the monitor.
Instructions for battery replacement, monitor conversion, and component replacement.
Technical specifications, operating, and storage conditions for the Ventis MX4.
Detailed sensor specifications and cross-sensitivity data for various gases.
Information on monitor certifications, marking requirements, and warranty terms.
To Next Page