Ventis MX4 - Monitor Setup and Configuration; Unpacking and Initial Setup

Ventis™ MX4 Product Manual
7 © 2014 Industrial Scientific Corporation
The Ventis MX4 monitor functions as an independent device to monitor the environment for hazardous gas
concentrations. It is also part of the Ventis System including products that charge, calibrate, bump test, datalink,
protect, and otherwise enable or enhance use of the monitor and its data. (Datalink refers to capabilities that enable
access to the download and use of monitor datalogs, reports, and other information.) For a complete list of the Ventis
MX4 system of products, please refer to the manual section, Products and Parts.
►Unpacking the Monitor
CONTENTS
The monitor box contains the following items including, when ordered, those marked optional. Each item ordered
should be accounted for in the unpacking process.
Quantity Item Notes
1 as ordered Ventis MX4 Portable Multi-gas
Monitor
The monitor type is indicated on the box label.
Options:
 Ventis MX4 Diffusion
 Ventis MX4 Aspirated
 Ventis MX4 Aspirated with Conversion Kit
1 Ventis MX4 Reference Guide A companion to the Ventis MX4 Product Manual.
1 installed as ordered
Battery Pack One of three battery types is factory installed as
indicated on the box label. Options:
 Rechargeable Lithium-ion
 Rechargeable Extended Range Lithium-ion
 Alkaline
1 as ordered Charger Universal power cord. AC charger products include
interchangeable plugs (US, UK, EU, and AUS).
0 or 1 Calibration Cup Diffusion – 1 included
Aspirated – 0 included
1 Calibration and Bump Test
Tubing
Diffusion – two feet of clear tubing
0 or 1 In-field Sampling Tubing Diffusion – 0 included
Aspirated – Ten feet of black tubing
1 Final Inspection & Test Report Contains the following factory set* information:
 Monitor Set-up Date
 Monitor Part Number (P/N)
 Monitor Serial Number (S/N)
 For Each Sensor*:
 P/N
 S/N
 Type
 Location
 Alarm level values
 Span gas values
 Span reserve values
*Some factory set sensor values subject to user changes.
1 Warranty Card --
REPORTING A PROBLEM
After unpacking, if any item is missing or appears to have been damaged, contact a local distributor of Industrial
Scientific products or Industrial Scientific Corporation (for contact information, please see the manual’s last page).