Network Camera User’s Guide
31/83
The Network Camera can directly connect to the ADSL, however, it should be setup on
LAN environment to setup the PPPoE information, and then connect to the ADSL
modem. Power on again, then the Network Camera will dial on to the ISP connect to the
WAN through the ADSL modem.
The procedures are
• Connect to the LAN by DHCP or Fixed IP
• Access the Network Camera, enter Setting Î Network.
• Check the radio button of “PPPoE Setting”.
• If the ADSL Modem and Network Camera were connected on a hub, after the
Network Camera information were inputted, and then you can press “Dial” to do
To Next Page
Loading...
Need help?
General