Changing Paper Roll
1. Hook your finger under the latch on the front of the terminal and lift up to swing the paper roll
cover open.
2. Remove any partial roll of paper in the printer tray by lifting it up.
3. Loosen the glued leading edge of the new paper roll or remove the protective strip. Unwind the
paper roll past any glue residue.
4. Hold the roll so the paper feeds from the bottom of the roll.
5. Drop the paper roll into the printer tray.
6. Pull paper up past the glue residue.
7. Close the paper roll cover by gently pressing directly on the cover until it clicks shut, allowing a
small amount of paper past the glue residue to extend outside the printer door.
8. Tear the paper off against the serrated metal strip in the printer.
5
To Next Page
Loading...
Need help?
General
