Verint Video Solutions 27
Nextiva S1900e Series User Guide
Wait for I-Frame—The indication of whether the receiver waits for an I-frame before
decoding video. This parameter appears only when the receiver is in Solo mode.
Delay Adjustment—The adjustment of the rendering delay versus the rendering fluidity
(absence of skipped frames). To reduce delay in the video at the cost of increasing
chances of jitter, set this value to 0. To avoid video jitter at the cost of increasing the
delay, set this value to 2. It is recommended to leave this value at 1. This parameter
appears only when the receiver is in Solo mode.
Receiver Mode—The indication of what is displayed on the monitor connected to the
S1970e-R. Possible values are:
Solo—The monitor displays the video stream coming from a unique transmitter
(default).
Quad—The monitor is split into four quadrants and displays at the same time four
video streams coming from four transmitters.
Guard Tour—The monitor displays four video streams one at a time in a cycling
mode.
Note: When changing the mode from Solo to Quad or Guard Tour (or vice versa), you
need to reboot the device for the modification to take effect.
Guard Tour Dwell Time—The period of time (in seconds) a video stream will be
displayed when the receiver is in Guard Tour mode. This parameter does not appear
when the receiver is in Solo mode.
Encoders
For each encoder on a transmitter, the video parameters are:
To Next Page
Loading...
Need help?
General
